An alternative way to customize your guitar nut
Before adjusting anything, make sure your guitar is set up properly and your neck is straight and not be bent or twisted. If the neck is bent to adjust the truss rod first. If the neck is warped, which requires extensive repair. To minimize the effect or to avoid fret buzz around the finger board may be necessary for your frets leveled and crowned himself first.
It takes a nut file set (available from Stewart MacDonald), and a good set of instruments as well. Different types of sandpaper are also useful.
Fret each string, starting with the high E, between the second and the third fret, use your meter to check the distance between the bottom of the string and the first covenant. They should be about 0.005 "spacing between the individual and touch the string hardly the second fret. If this measure is to close or be too dead to move on to the next string E string. You can close the gap in record time a piece of paper if they move across the fretboard, to see the height of the groove in the nut in relationship, the fretboard, how it works.
For most players a string height (in the jargon of the guitar as an "action") of 3 / 64 "inch is considered normal. Some players choose a higher sting height such as 4 / 64" inches, while the player is holding a light touch and want as quickly as possible measures tend to seek to complete the action as close as possible to the 2 / 64 "to reduce the number of very difficult to install and maintain without covenant buzz everywhere on the fretboard.
Of course you can use the traditional method to set the height of the chain in relation to the mother, through the use of several meters in thickness under the nut, and presentation to the depth and breadth of the factory. However, I have found this method to provide a better environment and a more consistent while playing near the nut.
Visit Now http://www.adultguitarlessons.com for more information about guitar lessons
Category Article Tips
